Haas TM-1 CNC Milling Machine for Sale
A like-new Haas TM-1 Mill for sale. It is an “open” model which I much prefer, as it’s much easier to do your set-up, adjust the coolant, watch the processes, etc. Some models have the big cabinet which takes up a lot more room. The base “footprint” is 41" wide and 44" front to back. Cabinet is 61" front to back and 52" wide plus the 16" aluminum addition I built that I only install when we're using it. We took the base off and the box on the top and it went in a 7' door! It needs a 9' ceiling or about a 1 foot by 2 foot hole in the ceiling! It weighs about 3300 lbs. It is “low miles” – 555:55 hours “cycle time” and 437:38 hours “spindle time”. Will run on 220 volt SINGLE PHASE! It can also be used as a manual mill and can also machine wood and plastics, etc.!
Coolant system that you program to go on and off.
15 Cat 40 tool holders ($1,000)
Machine programmed for “rigid tapping”; ($700 extra charge)
Parlec vise ($550)
You’ll see it doesn’t have a lot of running hours on it compared to the rusty junk in full-time machine shops!
I’ll pay to have it loaded onto your trailer.
Mill and nice assortment of tool holders, etc.